Shuffleboard Accessories (Pucks, Powders, Etc)

SPEED POWDERS

Shuffleboard Powder is one of the most important elements of playing the game.
Our powders are engineered for wooden shuffleboard tables with a factory-installed epoxy finish.

Not recommended for use on laminate surfaces.

Results may vary on concrete, but SunGlo products have not been engineered or tested for use on concrete.

These general guidelines can help you choose the powder that is right for you, but experience and personal preference also matter.

  • The lower the number, the faster the powder.
  • Speed 1 is the fastest powder and Speed 7 is the slowest.
  • Longer tables over 14 feet work best with faster powders – speeds 1 through 4
  • Shorter tables under 14 feet work best with slower powders – speeds 5 through 7
  • You may need to try several speeds to find the powder that best suits your playing preference

Simple rules to remember using SunGlo powder on your table’s surface.

  • Spray a thin layer of silicone and let it briefly air-dry before applying powder, that helps the powder do its job
  • Powder is like hot sauce – only use a little and add more if you need it.  It is easier to add more than take off too much
  • If your powder is ‘snowplowing’, the cause is ALMOST ALWAYS too much powder.  Try using less.
  • While SunGlo powders are moisture resistant, they should be stored in a dry location.
  • Your board will require occasional cleaning, see our “Maintenance and Performance” section for information.